Mahmood Bataee
Mahmood Bataee
Other namesMahmood Bathaee
Curtin University Malaysia
Verified email at
Cited by
Cited by
Investigation of various ROP models and optimization of drilling parameters for PDC and roller-cone bits in shadegan oil field
M Bataee, M Kamyab, R Ashena
International oil and gas conference and exhibition in China, 2010
Application of artificial intelligent systems in ROP optimization: a case study in Shadegan oil field
M Bataee, S Mohseni
SPE middle east unconventional gas conference and exhibition, 2011
Artificial neural network model for prediction of drilling rate of penetration and optimization of parameters
M Bataee, S Irawan, M Kamyab
Journal of the Japan Petroleum Institute 57 (2), 65-70, 2014
Comparison between bit optimization using artificial neural network and other methods base on log analysis applied in Shadegan oil field
M Bataee, S Edalatkhah, R Ashna
International Oil and Gas Conference and Exhibition in China, 2010
Neural networks in BHCP prediction performed much better than mechanistic models
R Ashena, J Moghadasi, A Ghalambor, M Bataee, R Ashena, A Feghhi
International Oil and Gas Conference and Exhibition in China, 2010
Review of geomechanical application in reservoir modeling
M Bataee, S Irawan
Journal of Applied Sciences 14 (10), 981-990, 2014
Calculation of temperature profile in injection wells
B Moradi, M Ayoub, M Bataee, E Mohammadian
Journal of Petroleum Exploration and Production Technology 10 (2), 687-697, 2020
International Oil and Gas Conference and Exhibition in China
M Bataee, M Kamyab, R Ashena
Beijing, 2010
Application of smart nano-WBM material for filtrate loss recovery in wellbores with tight spots problem: an empirical study
A Zamani, M Bataee, Z Hamdi, F Khazforoush
Journal of Petroleum Exploration and Production Technology 9 (1), 669-674, 2019
Comparison of CO2 and nitrogen injection at low temperatures in high temperature reservoirs for improving oil recovery
Z Hamdi, M Awang, A Basyouni, H Hematpour, M Bataee
Abu Dhabi international petroleum exhibition & conference, 2016
The effects of geomechanics on the WAG injection model
M Bataee, S Irawan, S Majidaie
Offshore Technology Conference-Asia, 2014
Cold CO2 injection for balancing interfacial tension decrease and viscosity increase
Z Hamdi, M Awang, M Bataee, M Kamyab
SPE Asia Pacific Oil & Gas Conference and Exhibition, 2016
Oil well compressive strength analysis from sonic log; a case study
Z Hamdi, MS Momeni, B Meyghani, D Zivar, BY Chung, M Bataee, ...
IOP Conference Series: Materials Science and Engineering 495 (1), 012077, 2019
Numerical modeling of flow and temperature distribution in heterogeneous wellbore medium
S Irawan, M Bathaee
SPE Middle East Oil & Gas Show and Conference, 2015
Production optimization using different scenarios of gas lift and ESP installation
M Bataee, MZ Reisabadi, A Yahyazadeh
International Journal of Petroleum and Geoscience Engineering (IJPGE) 1 (1 …, 2013
Wellbore failure during water-alternating-gas injection by use of flow-stress coupling method
M Bataee, S Irawan, S Ridha, H Hematpour, Z Hamdi
SPE Journal 22 (01), 172-183, 2017
Application of Artificial Intelligent Systems in ROP Optimization: a Case Study
S Mohseni, M Bataee, RM Sulak, LK Thomas, RR Boade
SPE Middle East Unconventional Gas Conference and Exhibition 31, 1272-1278, 2011
Experimental investigation on mobility reduction factor of surfactant-alternating-gas foam flooding
H Hematpour, SM Mahmood, NH Nasr, M Bataee
Kuwait Journal of Science 46 (4), 2019
Porosity and permeability alteration around wellbore during injection process
M Bataee, S Irawan
International Journal of Geomechanics 18 (2), 04017145, 2018
Development of stress model near the wellbore using an iterative coupling method
M Bataee, S Irawan, F Namazi-saleh, S Ridha
International Journal of Geomechanics 17 (2), 04016047, 2017
The system can't perform the operation now. Try again later.
Articles 1–20