Saravanan Karuppanan
Saravanan Karuppanan
Verified email at
Cited by
Cited by
Impact resistance and damage tolerance of fiber reinforced composites: A review
SZH Shah, S Karuppanan, PSM Megat-Yusoff, Z Sajid
Composite Structures 217, 100-121, 2019
Contact stress analysis of helical gear pairs, including frictional coefficients
SS Patil, S Karuppanan, I Atanasovska, AA Wahab
International Journal of Mechanical Sciences 85, 205-211, 2014
A review of surface deformation and strain measurement using two-dimensional digital image correlation
SW Khoo, S Karuppanan, CS Tan
Metrology and Measurement Systems 23 (3), 2016
Experimental measurement of strain and stress state at the contacting helical gear pairs
SS Patil, S Karuppanan, I Atanasovska
Measurement 82, 313-322, 2016
Crack tip stress intensity factors for a crack emanating from a sharp notch
AG Philipps, S Karuppanan, CM Churchman, DA Hills
Engineering Fracture Mechanics 75 (18), 5134-5139, 2008
A theoretical and experimental investigation into the development of coverage in shot peening
S Karuppanan, JS Romero, E R, A Levers
Shot Peening, 101-107, 2002
Frictional tooth contact analysis along line of action of a spur gear using finite element method
S Patil, S Karuppanan, I Atanasovska, AA Wahab
Procedia Materials Science 5, 1801-1809, 2014
Sliding frictional contact between a square block and an elastically similar half-plane
S Karuppanan, CM Churchman, DA Hills, E Giner
European Journal of Mechanics-A/Solids 27 (3), 443-459, 2008
Burst Strength Analysis of Corroded Pipelines by Finite Element Method
CT Belachew, MC Ismail, S Karuppanan
Journal of Applied Sciences 11, 1845-1850, 2011
Frictional complete contacts between elastically similar bodies subject to normal and shear load
S Karuppanan, DA Hills
International Journal of Solids and Structures 45 (17), 4662-4675, 2008
FEM analysis of sezawa mode SAW sensor for VOC based on CMOS compatible AlN/SiO2/Si multilayer structure
MZ Aslam, V Jeoti, S Karuppanan, AF Malik, A Iqbal
Sensors 18 (6), 1687, 2018
Evaluation of available codes for capacity assessment of corroded pipelines
CT Belachew, M Che Ismail, S Karuppanan
Performance comparison of resin-infused thermoplastic and thermoset 3D fabric composites under impact loading
SZH Shah, PSM Megat-Yusoff, S Karuppanan, RS Choudhry, F Ahmad, ...
International Journal of Mechanical Sciences 189, 105984, 2021
Experimental study of low velocity impact response of carbon/basalt hybrid filament wound composite pipes
NH Farhood, S Karuppanan, HH Ya, M Ovinis
International Journal of Structural Stability and Dynamics 18 (07), 1850089, 2018
Contact Pressure evaluation of a gear pair along the line of action using finite element analysis
S Patil, S Karuppanan, AA Wahab
Applied Mechanics and Materials 393, 403-408, 2013
Contact stress evaluation of involute gear pairs, including the effects of friction and helix angle
SS Patil, S Karuppanan, I Atanasovska
Journal of Tribology 137 (4), 044501, 2015
Basalt carbon hybrid composite for wind turbine rotor blades: a short review
AN Mengal, S Karuppanan, AA Wahab
Advanced Materials Research 970, 67-73, 2014
Burst Pressure Estimation of Corroded Pipeline with Interacting Defects using Finite Element Analysis
S Karuppanan, AS Aminudin, AA Wahab
Journal of Applied Sciences 12 (24), 2626-2630, 2012
CFD Simulation of Bubbling Fluidized Bed: Effect of Distributor Plate Orifice Pattern Configuration on Hydrodynamics of Gas-Solid Mixing
IE Afrooz, CM Sinnathambi, S Karuppanan, DLC Ching
ARPN Journal of Engineering and Applied Sciences 11 (20), 11954-11959, 2016
Finite element analyses of corroded pipeline with single defect subjected to internal pressure and axial compressive stress
T Arumugam, S Karuppanan, M Ovinis
Marine Structures 72, 102746, 2020
The system can't perform the operation now. Try again later.
Articles 1–20