Follow
Michael Njoroge Gitau
Michael Njoroge Gitau
Verified email at up.ac.za
Title
Cited by
Cited by
Year
Review on DC collection grids for offshore wind farms with high‐voltage DC transmission system
K Musasa, NI Nwulu, MN Gitau, RC Bansal
IET Power Electronics 10 (15), 2104-2115, 2017
682017
Power processor for interfacing battery storage system to 725 V DC bus
MN Gitau, G Ebersohn, JG Kettleborough
Energy Conversion and Management 48 (3), 871-881, 2007
352007
Analysis and design of a single-phase tapped-coupled-inductor boost DC-DC converter
MN Gitau, FM Mwaniki, IW Hofsajer
Journal of Power Electronics 13 (4), 636-646, 2013
302013
Modeling conducted EMI noise generation and propagation in boost converters
MN Gitau
ISIE'2000. Proceedings of the 2000 IEEE International Symposium on …, 2000
282000
Modeling and control of voltage source converters for grid integration of a wind turbine system
E Hamatwi, IE Davidson, MN Gitau, GP Adam
2016 IEEE PES PowerAfrica, 98-106, 2016
252016
Dynamic analysis of DC–DC converter internal to an offshore wind farm
K Musasa, MN Gitau, RC Bansal
IET Renewable Power Generation 9 (6), 542-548, 2015
212015
Multilevel switched-capacitor DC-DC converter with reduced capacitor bank
MN Gitau, CL Kala-Konga
IECON 2010-36th Annual Conference on IEEE Industrial Electronics Society …, 2010
192010
Rotor speed control of a direct-driven permanent magnet synchronous generator-based wind turbine using phase-lag compensators to optimize wind power extraction
E Hamatwi, IE Davidson, MN Gitau
Journal of Control Science and Engineering 2017, 2017
172017
Unified approach for synthesis and analysis of non-isolated DC-DC converters
MN Gitau, GP Adam, L Masike, MWK Mbukani
IEEE Access 9, 120088-120109, 2021
152021
Steady‐state and small‐signal models of a three‐phase quasi‐Z‐source AC–DC converter for wind applications
CL Kala‐Konga, MN Gitau, RC Bansal
IET Renewable Power Generation 10 (7), 1033-1040, 2016
152016
Low cost power lead extended pre-compliance conducted EMI measurement setup and diagnostics with compact LISN
I Grobler, MN Gitau
2013 IEEE ECCE Asia Downunder, 1144-1149, 2013
142013
Three-phase quasi-Z-source rectifier modeling
CLK Konga, MN Gitau
2012 Twenty-Seventh Annual IEEE Applied Power Electronics Conference and …, 2012
142012
Modelling and measurement of high‐frequency conducted electromagnetic interference in DC–DC converters
I Grobler, MN Gitau
IET Science, Measurement & Technology 11 (4), 495-503, 2017
132017
Analysis, modelling and measurement of the effects of aluminium and polymer heatsinks on conducted electromagnetic compatibility in DC–DC converters
I Grobler, MN Gitau
IET Science, Measurement & Technology 11 (4), 414-422, 2017
132017
Performance analysis of power converter based active rectifier for an offshore wind park
K Musasa, MN Gitau, R C. Bansal
Electric Power Components and Systems 43 (8-10), 1089-1099, 2015
132015
Conducted EMC modeling for accreditation in DC-DC converters
I Grobler, MN Gitau
IECON 2015-41st Annual Conference of the IEEE Industrial Electronics Society …, 2015
112015
Analysis of a DC collector-based power converter topology for an offshore wind farm
K Musasa, MN Gitau, RC Bansal
Electric Power Components and Systems 43 (8-10), 1113-1121, 2015
112015
High boost‐ratio bidirectional converter for interfacing low‐voltage battery energy storage system to a DC bus
EG Muchina, L Masike, M Njoroge Gitau
IET Power Electronics 12 (9), 2372-2381, 2019
82019
Control of multi-level voltage source converters integrating a wind turbine system into the grid
E Hamatwi, IE Davidson, MN Gitau
2016 IEEE International Conference on Renewable Energy Research and …, 2016
82016
Analysis of a 4-phase tapped-inductor DC-DC converter for high boost ratio wide input voltage range applications
MN Gitau, IW Hofsajer
IECON 2014-40th Annual Conference of the IEEE Industrial Electronics Society …, 2014
82014
The system can't perform the operation now. Try again later.
Articles 1–20